If you're running full drag slicks, you need Steeda's new Driveshaft Safety Loop. This NHRA compliant safety device keeps the driveshaft from digging into the ground and reduces the chance of cockpit entry in the event of a driveshaft breakage.
The rear support of the twin rail design makes it stronger than the cantilever design of the competition. Because it installs onto existing hardware, there's no need to drill holes in the floorpan or remove your interior. It'll clear a 4" driveshaft and works with both 1 and 2-piece driveshafts. Best of all, the 2-piece loops mean you don't have to drop your driveshaft to install it.
- Dropping driveshaft not required.
- Stronger than the competition
- Mounts to existing hardware, no drilling required
- Also compatible with Tremec Magnum XL transmissions
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
- Installation Difficulty:
- Easy
- Tools Required:
- Basic Shop Tools
- Estimated Install Time:
- (approx.) 1 Hour
- Vehicle Fitment:
- 2005, 2006, 2007, 2008, 2009, 2010
- Vehicle Trim:
- V6
- Vehicle Trim:
- GT
- Vehicle Trim:
- Bullitt
- Vehicle Trim:
- GT500
- Origin:
- Made in the USA
