Steeda Ford Fusion V6 Sport Cold Air Intake (2010-2012)

Steeda Autosports the world's largest aftermarket manufacturer of Ford performance equipment is once again leading the performance market with our High Velocity Cold Air Intake (CAI) for the 2010/11 Ford Fusion 3.5L Sport.

This high performance CAI effectively opens up the intake system of Ford's Fusion Sport 3.5L V6 power plant and allows it to breath much more freely than the stock intake system allows.

Our engineers started with a large surface area high-flow nano-fiber air filter added our famous 'race-tested velocity stack entry and then designed a stainless steel heat shield with a durable rubber gasket to seal the shield against the vehicle's hood to prevent hot underhood air from being drawn into the airbox from the engine compartment.

Competitive intakes don't even bother to use a head shield on their intake designs and do not also provide a velocity stack which increases air velocity and streamlines the incoming air charge providing a clean mass air flow signal.

Streamlined airflow over the mass air sensor prevents turbulence across the mass air sensor. A clean mass air flow sensor signal is critical to perfect drivability and throttle response.

This intake was designed to work with the stock engine calibration and will provide a gain of up to 12hp at the wheels on its own.

Make sure to check out our Steeda Cold Air Intake and SCT tuner Power Pak! Combined with the SCT tune you get an increase of up to 25hp at the wheels on 91 octane fuel. Save money on the combo and get the most out of your Cold Air Intake for your Ford Fusion.

Product Benefits

• Does not get heat soaked like factory air box
• Cools to ambient temperature range significantly faster than the stock unit while producing more power
• Limited Lifetime Warranty - Backed by a trusted company that has been in business for over 20 years
• Up to 12hp at the wheels on the stock factory tuning
• Up to 25hp at the wheels when combined with our SCT tuning!
• Built in Velocity stack compresses and straightens incoming air eliminating turbulence across the MAF for greater gains than just having larger MAF housing and better throttle response.
• Does not require tune
• Steeda has been building Cold Air Intakes for Ford performance vehicles longer than any other company!

Warning: Not approved for sale in California or states that require a California E.O. #.This part has been designed and is intended for off-road application only. Installation of this part on a vehicle that is driven on public roads may violate U.S. and Canadian laws and regulations.

Note:Federal and several state and provincial laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. Steeda Autosports assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer's modifications and/or use of Steeda products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.

This limited warranty is the only express warranty applicable to Steeda Autosports products. Other rights may arise or vary from state to state in the United States. Steeda is not responsible for any time for which you may lose the use of your vehicle, any inconvenience you might be caused, the loss of your transportation or any part thereof, or any other incidental or consequential damages you may have.

WARNING: California Residents: Cancer and Reproductive Harm; www.p65warnings.ca.gov