Steeda's front lower control arms for S197 Ford Mustangs with 1st gen ball joints have higher durometer rubber bushings that are a great upgrade for stock and slightly modified (up to 3/4" lowered) spring heights. These replacement lower control arms use factory height ball joint studs and do not require bumpsteer correction. These arms are also compatible with all factory diameter wheels. The rubber bushings are slightly firmer than stock for improved handling and quicker steering response. The rubber bushings will not cause NVH, common with arms using too high a durometer polyurethane bushings.
Product Benefits:
- Higher durometer rubber bushings for improved suspension response
- No added NVH
- Direct fit for 2005-2010 S197 Mustang from stock height to 3/4" drop
Note: Due to the manufacturing changes on 2010 Mustang's and variations to the steering knuckle and ball joint pin, verify that these control arms are the proper fit for your S197. This control arm uses a 0.7" ball joint pin. Please contact Steeda if assistance is needed.
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
- Vehicle Fitment:
- 2005, 2006, 2007, 2008, 2009, 2010
- Vehicle Trim:
- V6
- Vehicle Trim:
- GT
- Vehicle Trim:
- Bullitt
- Vehicle Trim:
- GT500
