Steeda BOSS 302 Mustang SCT BDX Power Pack (2012-2013)

*Peak gains of up to 32 hp!*

As good as the BOSS 302 Mustang is, there is still room for improvement and Steeda has found it with our BOSS 302 Ultimate Induction Power Pack!

Designed in-house by our engineering staff specifically for the BOSS 302. The high performance CAI of our Power Pak effectively opens up the intake system of Ford's five-liter power plant and allows it to breath much more freely than the stock intake system allows - taking your BOSS 302 Mustang to the next level of performance.

Our engineers started with a large surface area high-flow nano-fiber air filter, added our famous 'race-tested' velocity stack entry and then designed a stainless steel heat shield with a durable rubber gasket to seal the shield against the vehicle's hood. Next we increased the MAF housing size to 101mm and coupled it to a new higher flowing Pro-Flow inlet hose with our Cool-Tube Technology.

To ensure the densest air charge possible we retained the factory cold air feed ducting from the front bumper. Steeda was the first company to do this starting in 2010 with our 2010 GT intake and have carried this innovation over to the 2011-12 models. We also sealed the stainless steel shield to the hood to prevent any hot air from being sucked in from around the engine compartment. Some manufacturers have chosen to ignore the factory cold air ducting. Some claim they use it when it is really just hanging there blowing air into an open, unsealed compartment. While others don't bother to seal and isolate the airbox, which are all keys to keeping the lowest air charge temperatures possible. Also, our billet aluminum velocity stack and high flow air filter ensure a clean, streamlined air charge into the engine.

This Cold Air Intake is so effective at improving airflow into the five-liter engine that a performance tune is not just recommended, it is required for maximum performance! In an effort to maximize performance and provide our customers with only the very best products we have partnered with the leader in automotive tuning - SCT Performance and their SCT BDX tuning device.

SCT Performance is the leader in the Ford tuning industry and Steeda's partner in developing this powerful package.

"SCT has seen the highest horsepower and torque results while using Steeda's Cold Air Kit, over any other brand." - Chris Johnson, President of SCT Performance

Combined with the included custom tune using an included SCT BDX programming device we have achieved dramatic power increases.

Peak to Peak gains of up to 28hp and 22ft/lbs of torque have been achieved, with point to point gains of as much as 32 horsepower and 25 ft/lbs of torque!

Our power increase it not just a peak number at one point in the band. The actual power increase is spread throughout the entire rpm range so your increased performance is available on demand in any gear at virtually any rpm!

Note: requires a minimum of 91 octane fuel for power gains. Please provide your 4 digit processor code off your PCM sticker located on the front passenger side of the engine compartment for your calibration.

Please contact our Steeda sales reps if you need assistance finding this code.

You can purchase the cold air intake by itself if you already own a flash programming device and intend to have your own custom tuning done. Check out our BOSS 302 Cold Air Intake by itself by clicking here.

Warning: Not approved for sale in California or states that require a California E.O. #. This part has been designed and is intended for off-road application only. Installation of this part on a vehicle that is driven on public roads may violate U.S. and Canadian laws and regulations. Steeda Tuning will not change, remove or alter any emissions control devices on your vehicle.

NOTE: . Federal and several state and provincial laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. Steeda Autosports assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer's modifications and/or use of Steeda products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.

This limited warranty is the only express warranty applicable to Steeda Autosports products. Other rights may arise or vary from state to state in the United States. Steeda is not responsible for any time for which you may lose the use of your vehicle, any inconvenience you might be caused, the loss of your transportation or any part thereof, or any other incidental or consequential damages you may have.

WARNING: California Residents: Cancer and Reproductive Harm; www.p65warnings.ca.gov