Steeda's cold air high-flow intake for the 03-04 Cobra features a reusable dual cone filter with more surface area than single cone models to flow the most air.
The Steeda high velocity air intake features a stainless steel heat shield that seals against the hood shielding more of the air from the engine compartment heat than the competitions models.
This intake is good for 14 to 18 RWHP on a stock Cobra and has been dyno tested in our Pompano Beach facility to add up to 25 RWHP on a modified Cobra.
All the necessary hardware is included for a direct bolt-on installation. Used in cars exceeding 600 rear wheel horsepower!
Read more about the advantages in Steeda Mustang Cold Air Intakes over the competitors on our blog: https://www.steedablog.com/2012/03/mustang-cold-air-intake-truth/
Warning: Not approved for sale in California or states that require a California E.O. #. This part has been designed and is intended for off-road application only. Installation of this part on a vehicle that is driven on public roads may violate U.S. and Canadian laws and regulations.
Note: Federal and several state and provincial laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. Steeda Autosports assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer's modifications and/or use of Steeda products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.
This limited warranty is the only express warranty applicable to Steeda Autosports products. Other rights may arise or vary from state to state in the United States. Steeda is not responsible for any time for which you may lose the use of your vehicle, any inconvenience you might be caused, the loss of your transportation or any part thereof, or any other incidental or consequential damages you may have.
- Does not get heat soaked like factory air box
- Cools to ambient temperature range significantly faster than the stock unit while producing more power
- Added horsepower and torque
- Lifetime filter
- Keeps hot air out, cold air in
- Stainless Steel Housing & Shield
- Steeda has been building Cold Air Intakes for Ford performance vehicles longer than any other company!
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
- Installation Difficulty:
- Easy
- Tools Required:
- Basic Shop Tools
- Estimated Install Time:
- (approx.) 1 Hour
- Vehicle Fitment:
- 2003, 2004
- Vehicle Trim:
- Cobra
- Engine Displacement:
- 4.6
- Air Filter Type:
- Oiled
- Cold Air Intake Type:
- Open Element
- Origin:
- Made in the USA
