This K&N high-flow performance air intake system is a free-flowing, mandrel-bent aluminum tube air induction system designed to fit 5.0L F-150 models for up to 13.8 HP increase. The restrictive factory air filter and air intake housing on your vehicle are replaced by this K&N air intake system which is designed to dramatically reduce air flow restriction as it smoothes and straightens air flow. The improved airflow allows your engine to inhale a larger amount of air than it would from the stock air intake. More air means more usable power and acceleration throughout your engine's RPM range. The air intake comes with a chrome topped K&N high-flow air filter and a heat shield that installs onto the lower air box. Air is directed through the intake tube into the engine's throttle body for a guaranteed power gain. The oversized cone shaped air filter can be used for up to 100,000 miles before servicing is needed depending on driving conditions. This air intake is relatively easy to install usually in 90 minutes or less using existing factory mounting points. The tools needed are a screwdriver and an Allen wrench.
2018 FORD F-150 5.0L V8 F/I - All Street Legal In All US States: No
2017 FORD F-150 5.0L V8 F/I - All Street Legal In All US States: No
2016 FORD F-150 5.0L V8 F/I - All Street Legal In All US States: No
2015 FORD F-150 5.0L V8 F/I - All Street Legal In All US States: Yes CARB EO Number: D-269-46
Warning: Not approved for sale in California or states that require a California E.O. #. This part has been designed and is intended for off-road application only. Installation of this part on a vehicle that is driven on public roads may violate U.S. and Canadian laws and regulations.
Note: Federal and several state and provincial laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. Steeda Autosports assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer's modifications and/or use of Steeda products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.
- Increases performance, MPG, & power up to 13.86 HP @ 4553 RPM
- Easy to install in minutes with basic hand tools
- Cotton Gauze oiled filter for superior airflow and easy cleaning w/ great looking free-flowing aluminum tube
- 2015 F-150 5.0L CARB EO Number D-269-46
- 2016-2018 Models Warning: Not approved for sale in California or states that require a California E.O. #.
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
- Vehicle Fitment:
- 2015, 2016, 2017, 2018, 2019, 2020
This aftermarket part has been granted an Executive Order (E.O.) and is approved for sale and use on
motor vehicles by the California Air Resources Board (C.A.R.B.). In addition to California, this part is
also legal in those states having adopted California clean air standards.
