The K&N 69-3539TB Typhoon air intake system is a free-flowing, mandrel-bent aluminum tube air induction system designed to fit some Ford Focus models. The restrictive factory air filter and air intake housing are replaced by the K&N Typhoon air intake which is designed to dramatically reduce air flow restriction as it smoothens and straightens air flow. This allows your engine to inhale a larger amount of air than the factory air intake. More air means more usable power and acceleration throughout the engines RPM range. The 69-3539TB air intake comes with a black rubber topped K&N high-flow air filter and a heat shield that installs using the factory mounting locations. A molded scoop funnels outside air towards the filter. Air is then directed through the intake tube into the engines throttle body for a guaranteed power gain. The intake tube has an attractive blue powder-coat finish to match the cars badging and it accommodates the factory air pressure sensor. The oversized cone shaped air filter can be used for up to 100, 000 miles before servicing is needed depending on driving conditions. This air intake is relatively easy to install usually in 90 minutes or less using existing factory mounting points. Installation can be done using common tools.
Warning: Not approved for sale in California or states that require a California E.O. #. This part has been designed and is intended for off-road application only. Installation of this part on a vehicle that is driven on public roads may violate U.S. and Canadian laws and regulations.
Note:Federal and several state and provincial laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. Steeda Autosports assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer's modifications and/or use of Steeda products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.
Purchase your Mountune Focus RS High Flow Induction Kit in Black for your 2016-2018 Focus RS from Steeda Autosports today!
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
- Installation Difficulty:
- Easy
- Tools Required:
- Basic Shop Tools
- Estimated Install Time:
- (approx.) 1.5 Hours
- Vehicle Fitment:
- 2016, 2017, 2018
