This Airaid cold air intake system directly replaces the factory cold air system on your 2005-2009 4.6L Mustang GT and provides up to 17 horsepower over the factory airbox using the factory engine calibration.
This intake was designed with a restrictor in place in order to not require custom tuning and runs perfectly on the original engine calibration. For even more performance, the included restrictor can be removed and combined with SCT custom tuning gains of up to 40 horsepower can be achieved!
This intake ties properly into the factory cold air ducting system to keep air charge temperatures as low as possible and includes washable air filter that will last for years to come.
Warning: Not approved for sale in California or states that require a California E.O. #. This part has been designed and is intended for off-road application only. Installation of this part on a vehicle that is driven on public roads may violate U.S. and Canadian laws and regulations.
Note: Federal and several state and provincial laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. Steeda Autosports assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer's modifications and/or use of Steeda products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.
This limited warranty is the only express warranty applicable to Steeda Autosports products. Other rights may arise or vary from state to state in the United States. Steeda is not responsible for any time for which you may lose the use of your vehicle, any inconvenience you might be caused, the loss of your transportation or any part thereof, or any other incidental or consequential damages you may have.
- Does not require custom tune
- Up to 17 horsepower on factory tune
- CARB EO: D-609-18 ( 2005-2006 built after 4/30/2005)
- Easy direct bolt on installation
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
- Installation Difficulty:
- Easy
- Tools Required:
- Basic Shop Tools
- Estimated Install Time:
- (approx.) 1 Hour
- Vehicle Fitment:
- 2005, 2006, 2007, 2008, 2009
This aftermarket part has been granted an Executive Order (E.O.) and is approved for sale and use on
motor vehicles by the California Air Resources Board (C.A.R.B.). In addition to California, this part is
also legal in those states having adopted California clean air standards.
